Skip to product information
In stock
SKU:- K151568 | Part Number:- K151568
Sale price
$1,477.32
Regular price
The Knorr Bremse Steering Angle Sensor K151568 is a steer angle sensor used in heavy-duty commercial vehicle steering and stability control systems. It measures steering column position on a shaft diameter of approximately 24.90 mm and communicates angle data over the vehicle CAN bus at 250 Kilobaud. Operating on an 8�16 VDC supply with 24 V overvoltage tolerance, it draws a maximum of 150 mA, making it suitable for modern truck and bus electrical systems. The unit uses a Bosch 7-pin male connector with a 90� orientation and carries an IP50 ingress protection rating, providing dust protection in cab-mounted locations. It is specified to work reliably from -40 �F to 185 �F (-40 �C to 85 �C), covering a wide range of Australian operating conditions. Supplied as an aftermarket new component, this sensor supports Bendix electronic stability and collision avoidance systems where accurate steering angle feedback to the ECU is required.
- CAN Baud Rate: 250 Kilobaud - Connector Orientation: 90 - Connector Type: Bosch 7-Pin Connector (Male) - Current (Maximum): 150 mA - Ingress Protection Rating: IP50 - Maximum Operating Temperature: 185 F (85 C) - Minimum Operating Temperature: -40 F (-40 C) - Operating Voltage Range: 8 VDC - 16 VDC - Overvoltage: 24 V - Steering Column Shaft Diameter: 24.90 mm - Used in heavy-duty commercial vehicles as part of the steering and stability control system - Suits steering columns with approximately 24.90 mm shaft diameter - Interfaces with vehicle CAN bus at 250 Kilobaud for steering angle data communication - Operates on 816 VDC vehicle electrical systems with 24 V overvoltage protection - Bosch 7-pin male connector with 90 orientation for compact harness routing - IP50 ingress protection rating for resistance to dust in cab environments - Functions reliably from -40 F to 185 F (-40 C to 85 C) for wide climate use - Maximum current draw of 150 mA to minimise electrical load on vehicle systems - Marketed as an aftermarket new replacement component for existing Bendix systems - Supports electronic stability and collision avoidance systems by providing steering angle feedback - Helps maintain consistent steering control information to vehicle ECUs - Compact sensor body suited to tight steering column installations in trucks and buses - Country of origin PT for traceable manufacturing source - Follow cautionary note that fastener torque is critical to maintain correct sensor alignment - Ensure correct orientation during installation to avoid inaccurate steering angle readings
